Device Reset Instructions

This document provides step-by-step instructions for performing a configuration reset on the device using the physical Reset and CFG buttons. This method can be used to troubleshoot device behavior or restore factory settings

Requirements

• A small Phillips screwdriver or a similar pointed tool (to press the small buttons).

• Access to the device.

Steps to Reset the Device

1. Locate the Buttons
   The device has two small buttons labeled:

   • Reset

   • CFG (Configuration)

2. These are usually found on the front or side of the device housing.

3. Initiate the Reset Process

   • Using a small Phillips screwdriver:

     • Press the Reset button once — do not hold it down.

     • Then, press and hold the CFG button for at least 20 seconds.

     • Maintain consistent pressure throughout this duration.

4. Power Cycle the Device

   • After holding the CFG button:

     • Turn off the device completely.

     • Wait for 5–10 seconds.

     • Turn the device back on.

Outcome

After completing these steps, the device should:

• Clear previous configurations.

• Boot with default settings (if applicable).

• Be ready for new configuration or normal operation.

Troubleshooting Tips

• If the device does not respond after a reset:

  • Ensure buttons were pressed correctly.

  • Confirm power supply is stable.

  • Retry the procedure, ensuring the CFG button is held for the full 20 seconds.